Jump to content
The Classic Speaker Pages Discussion Forums

Aaron Hoyle

Members
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Aaron Hoyle

  • Rank
    Newbie
  1. Aaron Hoyle

    Question about tweeters on VR30

    It was the prior owner. I was given the VR30's due to him not finding replacement tweeters after I discovered them blown when he hired me to set up a new preamp/amp combo in his new house. Along the VR30's, he had a VR12 that also had a blown tweeter. I am also at a loss as to how he managed to blown them.. when I asked about his listening habits and prior setup he said "loud, I had a Yamaha amp driving them" and was all the information he could provide.
  2. Aaron Hoyle

    Question about tweeters on VR30

    Hi there, this question is directed to Steve F but anyone with knowledge on the subject is certainly welcome to give input. I have a pair of VR30's that both have blown tweeters.. after carefully disassembling the tweeters I have found that both of the tweeters had the lead separate from the end of the voice coil in the same place (at the solder joint) but I have been unable to solder the two together without leaving a glob of solder larger than the voice coil gap. Perhaps someday I'll be able to get them repaired or find a pair for a reasonable price used, for the time being I have an extra pair of tweeters from a pair of CR9's that I purchased from Ebay that I obtained for a reasonable price (Lynnfield tweeters come up very rarely). My question is what the consequences will be if I install the CR9 Kortec tweeter in the VR30 cabinet, particularly if the crossover is set lower in frequency on the VR30 for the Kortec tweeter to handle (or smoothly respond at), if the Kortec sensitivity is different than that of the Lynnfield tweeter and finally if there would be any advantage of swapping the front plates with the AMD ducts on to the Kortec tweeters (they have the same front plate dimensions). I assume the AMD ducts are tuned specifically for the aluminum Lynnfield tweeter, but thought it was worth asking just in case. On another subject, I have a pair of CR8's that I have modified by adding mass loaded epoxy to the corrugated plastic rear panels, added a tensioned brace between the side panels in the lower 2/3rd behind the woofer, lined the walls with high density acoustic eggcrate foam, replaced the 1uf electrolytic cap with a precision steel sealed paper in oil Tektronix caps and bypassed the other electrolytic caps with Sprague film/foil caps and they sound absolutely FANTASTIC. If anyone is interested I'll be happy to post pictures of the modifications. Thanks for your time! Aaron
×