Jump to content
The Classic Speaker Pages Discussion Forums
Sign in to follow this  
fedeleluigi

AR-MST measurements

Recommended Posts

Risposta in frequenza in camera anecoica = Anechoic Response. It shows some irregularities especially at about 2500, 6000, 14000 Hz because of the destructive interferences at the microphone position caused by the use of 4 tweeters. See also the polar responses. 
Risposta in camera d'ascolto rilevata con "rumore rosa" attraverso filtri a terzi d'ottava = Room Response measured with pink noise through 1/3 Octave filters. 
Diagrammi polari = Polar Responses
(note that they are not so regular. Unfortunately 4 tweeters cause a lot of constructive and destructive interferences. In other words, waves with the same frequency emitted by different drivers combine and add together or cancel depending on their phase at the point where they combine).
Curva d'impedenza = Impedance 
Risposta ai transitori = Tone Bursts 


 

AR_MST.jpg

 

DISTORSIONE ARMONICA= ARMONIC DISTORTION at 90 and 95 dB (actually only at 500 Hz the II and III armonic distortion are measured at 90 and 95 dB. At the other frequencies the real SPL depends on the frequency response of each loudspeaker); the tables show the III and II armonic distortion for all the loudspeakers tested in that issue of the magazine. 
Numbers out of parenthesis are III armonic distortion. 
Numbers in parenthesis are II armonic distortion. 
Vin= Voltage employed to obtain 90 and 95 dB at 500 Hz  

AR-3ai_AR-MST_AR-Pi_One_distortion.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×