Jump to content

Cizek Model 1 Lower Output From One Channel.


David 62

Recommended Posts

I have a pr.of Cizek Model 1's that I had re-foamed.I also replaced the rheostats on both speakers and a Q switch on one of the two speakers.Yesterday I noticed that the output volume was slightly softer in one of the two speakers.I switched channels and the softer speaker stayed the same.I also noticed that when I flip the Q switch on the softer speaker,it doesn't change the volume output as much as the louder speaker.I plan to check the rheostats as well as the Q switch.I don't have any test equipment other than a volt/ohm meter.The crossover looks like a bear to work on with the chokes glued on over the top of the caps.Is there anything that I should check?Thanks!

Dave

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...