>Hi folks, >I have just finished disassembling of my AR-6 models.Woofer >foam is good un-expectedly; >Crossover I suppose need some new capacitor as electrolitic >caps do not last long; >Are there any special hinds from your experience,which way to >do it or just make it step by step > >P.S. >The big capacitor (Blue Sprague) have 10uF value for cutting >the tw, >anyone knows the other capacitor value, the one in parallel to >the Wf. >What value the Indutance? > >thanks. >ric. From my AR6 (European version) I read the Resistor//Capacitor combination to be 10//24uF. INDUSTRIAL Royalite long life 24 uF 50V NP. The inductor is #4 (0.88mH). I'm currently using the "Blue" capacitor and the sound is good. I will experiment with a polyPro (NorthCreek)as the crossover is around 2,000 Hz. I used a 10 Ohm North resistor from North Creek and a cheap 24uF cap until I can replace it. My resistors were damaged due to overheating, I had scorch marks on the fill! I expect to change the 24uF to polyPro (NorthCreek) when I can. The pdf shows two crossover circuits which I believe are correctly transcribed from pictures, but no guarantees, ok. Hope this helps.